set_coriolis_comp¶

Runs at once Any mode Takes control

Switch the Coriolis feedforward on or off for the whole robot. With it on, the robot adds the torque the joints exert on each other when several move at once (the Coriolis and centripetal effects), computed from the commanded position and speed of each control cycle.

It acts where the inertia feedforward does: EXEC and JOG motion, and real-time position streams while rti_set_dynamics_ff() is "stream" and rti_set_rate_limiter() is on. Without a commanded speed nothing is added.

The call returns as soon as the robot accepts it. latest_status() shows the switch in coriolis_comp once it is in force, and the robot's activity log records each change.

Syntax¶

robot.set_coriolis_comp(enabled)

Arguments¶

Name	Type	Default	Description
`enabled`	`bool`	required	`True` to add the Coriolis torque, `False` to stop adding it.

Default values¶

From config/system.xml <dynamics_feedforward><coriolis>, read when the robot software starts: on as shipped, and when the element is missing.

Returns¶

Any

Always None: the robot's answer carries no data.

Examples¶

robot.set_coriolis_comp(False)
robot.move_joints(90, -105, 165, 0, -30, 180)
robot.wait_idle()
robot.set_coriolis_comp(True)

Further details¶

Note

The torque is small at normal speeds; it grows with the square of the joint speeds.

Usage restrictions 3 codes

This command runs at once; it is not queued. The robot accepts it in any mode and state, from the client that holds control or when no client does.

It answers with one of these codes when it does not carry the command out:

[6101] Control held by another client — another client holds control; the message names it
[6003] Invalid arguments — the value was not true or false (1 / 0); this client always sends one of them
[6025] RTI not running or not answering — rTI did not answer within 1 s: it is not running or not responding. The command may still have taken effect

In Python, a code above raises CommandRejected; its number is the code. The call raises:

CommandRejected: Another client holds control. Or RTI refused it or did not answer within 1 s (Errors:).
RobotTimeout: The robot did not answer within 5 s.
RobotConnectionError: The client is not connected.

If the connection drops while the call waits for the robot's answer, it raises CommandRejected with the code CONNECTION_LOST (DISCONNECTED after disconnect()); while it waits for the robot's status, RobotConnectionError.

Like every immediate command, it also answers BAD_ARGS when a raw client sends a value the robot cannot read at all, and INTERNAL when it fails inside the robot.

Protocol¶

A client that does not use robotclient sends this over the TCP command protocol (port 29000) for the example above:

{"id": "c1", "cmd": "set_coriolis_comp", "args": [0]}