Skip to content

STEPFOC and Spectral Micro

STEPFOC and the Spectral Micro BLDC driver are sister drivers: similar hardware and similar firmware, each made for its kind of motor. The Spectral Micro drives three-phase brushless motors; STEPFOC drives two-phase stepper motors. They are not the same board and do not run the same firmware, but they are controlled and run practically the same way: the same CAN and UART commands, the same Python library, Motor GUI and bootloader.

What this means in practice:

  • The commands are practically the same. The CAN messages and UART commands of the Reference have the same IDs, names and layouts on both drivers; STEPFOC adds a few that only make sense on a stepper (homing against a sensor, open-loop stepping). A program written for one runs on the other.
  • The firmware releases go in step. A change that applies to both drivers comes to both, but not always in releases with the same number: the compatibility table lists the pairs. STEPFOC 108 matches Spectral Micro 107.
  • Calibration differs. A BLDC driver measures the motor's resistance and inductance and finds its pole pairs; STEPFOC cannot, so you enter the three values from the motor's datasheet before calibrating. See Motor parameters and calibration.
  • The motor terminals differ. A+, A−, B+, B− for the two stepper coils instead of U, V, W.
  • Some images on this site show a Spectral Micro. Where a photo or a screenshot shows the BLDC board, the procedure is the same for STEPFOC.

The guides under the Guides tab were written with the Spectral Micro; the code in them runs unchanged on STEPFOC.

Comments

Found a mistake on this page? Edit it on GitHub · Report it · Get help · This page as Markdown · llms.txt · The whole manual as PDF