Skip to content

Gripper

#Gripper

Set/GetArgument int: 0 or 1

Whether this driver is a gripper. Save it; #Default clears it.

Response: the flag


#Gripcal

ActionEnters gripper calibration mode

Starts the gripper calibration: the jaws find their end stops at 500 mA. It prints nothing when it ends; after about 24 s without both end stops it gives up, uncalibrated. Gripinfo shows the result.

Response: Gripper calibration!


#Grippos

Set/GetArgument int: 0 (open) to 255 (closed)Enters gripper mode

The position setpoint; also activates the gripper, sets the action bit and goes to gripper mode.

Response: the current position


#Gripvel

Set/GetArgument int: 0 to 255

The speed setpoint of gripper moves, 50 at power-up.

Response: the setpoint


#Gripcur

Set/GetArgument int: current in mA

The current limit of gripper moves, 400 mA at power-up. From firmware 109 a move uses its magnitude, at most the driver's 2800 mA (108 and older used it as sent); see the gripper manual for the safe range.

Response: the setpoint


#Gripact

Set/GetArgument int: 0 or 1

The activate bit.

Response: the bit


#Gripstop

Set/GetArgument int: 0 or 1

The gripper E-stop bit. While it is 1 the driver raises the gripper E-stop error on every control cycle: set it to 0, then Clear.

Response: the bit


#Gripinfo

Get

Prints the gripper state: calibrated, activated, end stops, position, current.

Response: the report


Comments


Found a mistake on this page? Edit it on GitHub · Report it · Get help · This page as Markdown · llms.txt · The whole manual as PDF