Planning the cell¶
A robot cell is the robot, what it works on, and the people around it. For a PAROL6 on a bench the plan fits on a page, and it is worth writing.
The person¶
One person runs the robot and sees all of it. Nobody else reaches into the workspace while it is enabled. The E-stop is within that person's reach, and so is the power supply's switch.
The space¶
- The arm's reach, 408 mm from the axis of joint 1 to the flange, plus the tool, and a margin for the elbow, which swings behind the base when the arm folds: a sphere of about half a metre.
- Nothing fragile inside it, and nothing that the arm could knock onto the floor.
- The cables and tubes outside the sweep, or fixed so the arm cannot catch them.
- For a robot that runs unattended or near others, an enclosure: acrylic panels on the profile frame are enough to keep hands out; the robot cannot break them.
The program¶
- Run every new program in the simulator first, at full speed, and watch for the arm folding into the base or the table.
- Start on the real robot at low speed: in the commander, low
v=or longt=in the moves (the speed slider only scales jogging); in the Python API, thespeedfraction of each move. - Make the first move of a program go from the after-homing pose to a known pose, so that a program started right after homing always begins safely.
- Use
Delay()and the inputs to wait for the world, rather than assuming it.
The tool and the parts¶
- The payload includes the tool. A gripper and a camera together can be most of the 0.5 kg the arm carries at full reach.
- A pneumatic gripper needs 5 to 7 bar (check your gripper's rating) and a valve wired to an output; the valve's two tubes decide whether it is normally open or closed (Pneumatics).
- Know what the gripper does at an E-stop and at a power loss. The E-stop leaves the gripper as it is: an electric gripper keeps its grip, and a pneumatic or vacuum gripper stays where the valve left it. When the power or the air goes, the vacuum gripper drops its part.
When something changes¶
Changing the tool, the base, the table height or the fixture changes the kinematics and the clearances. Update the tool in the software, check the limits with a slow jog, and run the programs in the simulator again.
Comments
Found a mistake on this page? Edit it on GitHub · Report it · Get help · This page as Markdown · llms.txt · The whole manual as PDF